Scrap-specific feeding
Review the opening and feed arrangement against the actual pipe, profile or sheet. Do not assume that every size can enter without preparation.
Size Reduction · SWP Series
SWP Plastic Crusher
Match the feed opening and cutting arrangement to the scrap you actually handle.
Review SWP crushing equipment for plastic pipe, profile and sheet scrap. Specify feed dimensions, resin, required regrind and the material-handling arrangement.
SWP
Typical Uses
- Pipe and profile offcuts
- Sheet and other plastic scrap
Photos, drawings and a run video of this machine are sent with your configuration.
Machine Type
Size Reduction
Series
SWP
Overview
Where The SWP Series Fits Your Process
The SWP series is designed for crushing plastic pipes, profiles, sheets and related scrap. The machine should be selected from the incoming product geometry and the required regrind, because a long hollow section creates a different feeding task from small offcuts.
Provide photographs and dimensions of representative scrap, including the largest pieces. Define the desired output form and how material will be fed, collected and reused. Where direct feeding of long products is required, confirm that requirement against the selected machine arrangement.
Design And Function
What The Machine Does On Your Line
Cutting and regrind review
Specify the cutting components and discharge arrangement for the named resin and required regrind. Material properties influence the practical configuration.
Access for maintenance
Consider blade inspection, cleaning and material changes when defining the installation. The usable workflow includes these routine tasks.
Model Selection
Not Sure Which Configuration Fits Your Line?
Send your material, product size and output target. We shortlist the model and the options with you before quotation.
Applications
Products And Processes It Serves
Pipe and profile offcuts
Supply the section, wall thickness and maximum feed length. Identify whether long pieces must be accepted directly.
Sheet and other plastic scrap
Provide thickness, width, shape and material condition, including any coatings or contamination relevant to reuse.
Selection
Points To Settle Before You Specify
Settle these points first and the quotation you receive can be compared line by line.
-
01
Feed preparation
List the scrap range and the preparation allowed before crushing. The largest feed item is a selection input, not an assumption.
-
02
Regrind requirements
Define the output size and intended reuse. Confirm whether the regrind goes directly to processing or to a further pulverizing stage.
Line Interfaces
Connecting It To The Rest Of Your Line
SWP Plastic Crusher
After It In The Line
MP Plastic PulverizerThese machines show the position in a typical line, not a confirmed match. Interfaces are checked for each configuration.
Complete Lines Using This Machine
Acceptance
Acceptance Points To Agree
Points worth writing into the order, so the run test before shipment proves what matters for your product.
Representative feed trial
Check material entry and crushing behavior using the actual scrap types included in the scope.
Regrind inspection
Evaluate output size, contamination and suitability for the intended reuse under the agreed conditions.
Technical FAQ
Questions Before You Specify
Need an answer for your own material or product? Ask Maggie directly.
Can long pipe be fed without pre-cutting?
Direct-feeding configurations are available for review, with the usable geometry determined by the selected machine. Provide maximum dimensions and confirm them in the scope.
Does a crusher produce finished powder?
Its usual task is size reduction to regrind. If powder is required, specify the powder target and review whether a separate pulverizing stage is needed.
What information is needed for blade selection?
Provide the resin, section, wall thickness, contamination condition and expected feed. Use the same information when discussing blade maintenance and replacement.
Configuration Request
Discuss Your SWP Plastic Crusher Configuration
Tell us what you need to produce, the required output and whether this is a new installation or a replacement. Share the information you already have so we can review the next configuration details with you.
Have These Ready
- Scrap material and photographs
- Maximum feed dimensions
- Allowed feed preparation
- Required regrind and intended reuse
- Loading, collection and utility details